Wiper Blade Assembly Replacement

Description:

Remove or Disconnect
1. Wiper blade assembly from the arm assembly.
^ Insert a narrow-bladed screwdriver into the slot over the retainer spring. Pivot the screwdriver so that the blade tip presses downward on the retainer spring and releases the blade from the pin of wiper arm assembly.
2. Insert from blade assembly.
^ Squeeze locking tabs together and pull the insert from the blade assembly.

IMPORTANT
^ Insert must be replaced if removed.

Install or Connect
1. The insert to the blade assembly.
A. position retainer at bottom end of the blade assembly.
B. Guide insert through blade assembly, making sure to engage the claws sets along the entire length of the blade.
C. Insert is fully sealed when both locking labs engage the claw set.
2. Blade assembly to the wiper arm assembly by snapping it into place.