Programming the Receiver

Transmitter Programming

1. Turn ignition switch to "OFF" position.
2. "RADIO" fuse from I/P fuse block.
3. Cycle ignition switch from "OFF" to "RUN" three times within five seconds until the door locks and hatch release cycle indicating the BCM is in programming mode.

^ Leave ignition switch in "RUN" position.

4. Press and hold BOTH "LOCK" and "UNLOCK" buttons on transmitter for 16 seconds.
A. Door locks will cycle once confirming that transmitter code is programmed.
^ The door locks must cycle completely to unlock before proceeding.
B. Any transmitter code that was previously programmed has been erased
C. Body control module (BCM) is now programmed to transmitter.

5. When programming BCM to match transmitters, first transmitter code matched will be stored in BCM memories unless second transmitter is matched at the same time. If programming BCM to match a second transmitter, repeat step 4. This must be done before "RADIO" fuse is installed.
6. Ignition switch to "OFF".
7. "RADIO" fuse to I/P fuse block.

Inspect
^ Operation of each transmitter.