General Brake Specifications
| Front Brake Rotor | Rotor Diameter(Nominal) | 10.945 Inch (in) | ||
| Lateral Runout | 0.005 Inch (in) | |||
| Thickness Variation | 0.0005 Inch (in) | |||
| Rotor Thickness (Maximum) | 1.26 Inch (in) | |||
| Minimum Thickness After Refinish | 1.25 Inch (in) | |||
| Discard Thickness | 1.209 Inch (in) | |||
| Rear Brake Rotor | Rotor Diameter (Nominal) | 11.535 Inch (in) | ||
| Lateral Runout (Rear) | Brake Rotor (On-Vehicle Condition) | 0.006 Inch (in) | ||
| Axle Shaft Flange | 0.002 Inch (in) | |||
| Thickness Variation | 0.0005 Inch (in) | |||
| Rotor Thickness (Maximum) | 0.787 Inch (in) | |||
| Minimum Thickness After Refinish | 0.733 Inch (in) | |||
| Discard Thickness | 0.724 Inch (in) | |||
| Refinishing Specifications | Ammco Brake Lathe | Rough Cut | Spindle Speed | 150 RPM |
| Depth of Cut (Per Side) | 0.006 To 0.025 Inch (in) | |||
| Tool Cross Feed (Per Revolution) | 0.01 Inch (in) | |||
| Anti-Chatter Silencer | Yes | |||
| Sand Brake Rotor (Swirl Pattern) | No | |||
| Finish Cut | Spindle Speed | 150 RPM | ||
| Depth of Cut (Per Side) | 0.004 To 0.006 Inch (in) | |||
| Tool Cross Feed (Per Revolution) | 0.002 Inch (in) | |||
| Anti-Chatter Silencer | Yes | |||
| Sand Brake Rotor (Swirl Pattern) | Yes | |||
| Accu-turn Brake Lathe | Finish Cut | 105 RPM | ||
| Depth of Cut | As Necessary | |||
| Tool Cross Feed (Per Revolution) | 0.003 Inch (in) | |||
| Anti-Chatter Silencer | Yes |