Cruise Control Module

Cruise Control Module:

The cruise control module (11) is mounted on the left engine compartment inner side rail using two cruise control module bracket bolts/screws (16).

Remove or Disconnect
1. Accelerator control cable splash shield bolts/screws from throttle body, if equipped.
2. Accelerator control cable splash shield from throttle body, if equipped.
3. Left-hand front bumper fascia lower deflector.
4. Cruise control cover (13) to access connectors.
5. Electrical connector from cruise control module (11).
6. Cruise control cable from cruise control module.
7. Bolts/screws (16).
8. Cruise control module (11) with bracket (12) from left engine compartment inner side rail.
9. Bolts/screws (10) attaching cruise control module (11) to bracket (12).
10. Cruise control module (11) from bracket (12).

Install or Connect

NOTICE: Refer to "Service Precautions".

1. Cruise control module (11) to bracket (12).
2. Bolts/screws (10) attaching cruise control module (11) to bracket (12).
Tighten
^ Bolts/screws (10) to 6 N.m (53 lb. in.).
3. Cruise control module (11) with bracket (12) to left engine compartment inner side rail.
4. Bolts/screws (16).
Tighten
^ Bolts/screws (16) to 10 N.m (89 lb. in.).
5. Cable to module.
6. Electrical connector to cruise control module (11).
7. Cruise control cover (13) over connectors.
8. Left-hand front bumper fascia lower deflector.
9. Accelerator control cable splash shield to throttle body, if equipped.
10. Accelerator control cable splash shield bolts/screws to throttle body, if equipped.
Tighten
^ Accelerator control cable splash shield bolts/screws to 1.9 N.m (17 lb. in.).
Adjust
^ Cable, if necessary.