Side Reveal Molding Replacement

Side Reveal Molding Replacement: Removal Procedure:

REMOVAL PROCEDURE
1. Remove the windshield weatherstrip side retainer.

Side Reveal Molding Replacement: Removal Procedure:

2. Remove the windshield side reveal molding screws.
3. Peel away the reveal molding with the applique from the windshield frame.

Side Reveal Molding Replacement: Removal Procedure:

4. Remove the applique from the reveal molding.
5. Clean all surfaces.

Side Reveal Molding Replacement: Installation Procedure:

INSTALLATION PROCEDURE
1. Insert the forward edge of the applique into the side reveal molding.
2. Firmly press the applique and the reveal molding together.
3. Replace the foam sealing tape if reusing the reveal molding.
^ Extend the tape 2.0 mm (0.08 in) beyond the reveal molding ends.
^ Do not stretch the tape to fit. The tape may shrink back, or creep, after installation, resulting in a gap which may cause a leak.

Side Reveal Molding Replacement: Installation Procedure:

4. Position the windshield side reveal molding on the windshield frame.
5. Install the windshield side reveal molding screws.

Tighten
Tighten the screws to 1.8 N.m (16 lb in).

NOTE: Refer to Fastener Notice in General Information.

Side Reveal Molding Replacement: Installation Procedure:

6. Install the windshield weatherstrip side retainer and weatherstrip.