Body - Rattle From A-Pillar Upper Fender Area
Bulletin No.: 07-08-63-004Date: May 25, 2007
TECHNICAL
Subject:
Rattle In Upper Fender and/or A-Pillar Area (Replace or Reposition Anti-Rattle Patch)
Models:
2007 Chevrolet Cobalt
2007 Pontiac G5
Condition
Some customers may comment on a rattle in the left or right upper fender or A-pillar area.
Cause
This condition may be caused by a mispositioned or missing anti-rattle patch. This allows the fender to make contact in the A-pillar, causing a rattle.
Correction
Remove the left or right fender and install or reposition the anti-rattle patch.
Remove the fender. Refer to Front Fender Replacement in SI.
After removing the fender, clean the upper inside corner of the fender of any dirt or oils.
Measure from the edge of the fender 16 mm (0.630 in) (2) and 7 mm (0.275 in) (1) from the top edge. Remove the backing from the anti-rattle patch and place it on the fender. Apply some pressure to the patch for proper adhesion. If repositioning the patch, clean the old adhesive from the patch and apply GM Instant Gel Adhesive.
Install the fender. Refer to Front Fender Replacement in SI.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
When ordering the anti-rattle patch from the WPC, include the number of patches needed (one or two).
IMPORTANT NOTE WHEN PRINTING THIS FORM: If the form prints out on two pages, make certain you fax BOTH pages so that the WPC receives all the needed information. Missing information will delay or prevent the part from being shipped.
Disclaimer