53. Cylinder Head Installation

Cylinder Head Installation

Tools Required

J 45059 Angle Meter





Important: Do not use any sealing material.

1. Install the cylinder head gasket to the block.
2. Install the cylinder head.





Important: Always use new cylinder head bolts.

Notice: Refer to Fastener Notice.

3. Install and tighten the cylinder head bolts in sequence.

* Tighten bolts 30 N.m (22 lb ft).
* Then turn all the bolts 155 degrees in sequence. Use the J 45059.




4. Install the front cylinder head bolts.

Tighten the cylinder head bolts to 35 N.m (26 lb ft).