65. Camshaft Position Sensor Housing Installation

Camshaft Position Sensor Housing Installation




1. Rotate the crankshaft until number 4 piston is at top dead center (TDC) on the compression stroke. Refer to the crankshaft damper-to-front-cover timing marks.
2. Install a NEW camshaft position sensor housing seal.




3. Align the timing mark on the housing with the timing mark on the hex shaft.




4. Install the camshaft position sensor housing.

Notice: Refer to Fastener Notice.

5. Install the camshaft position sensor housing studs.

Tighten the camshaft position sensor housing studs to 22 N.m (16 lb ft).