Wheel Stud Replacement (Disc Brake)

Wheel Stud Replacement (Disc Brake)

Tools Required

J43631 Ball Joint Remover

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5 Lug Wheel).
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement.




4. Using the J 43631, remove and discard the wheel stud.

Installation Procedure




1. Install the NEW wheel stud into the wheel bearing hub.
2. Add enough washers (3) in order to draw the stud into the hub.
3. Install the wheel nut (1) with the flat side against the washers.
4. Tighten the wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing hub flange.
5. Remove the wheel nut (1) and the washers (3).
6. Install the brake rotor. Refer to Rear Brake Rotor Replacement.
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5 Lug Wheel).
8. Lower the vehicle.