Clutch Drive Plate and Clutch Driven Plate (M86)

Clutch Drive Plate and Clutch Driven Plate (M86)

Tools Required

J43482 Clutch Alignment Arbor

Removal Procedure

1. Remove the transmission. Refer to Transmission Replacement for the - M86/M94 Getrag transaxle.




2. Remove the clutch cover bolts one turn at a time, until spring pressure is relieved.




3. Remove the clutch cover and the clutch disc.

Installation Procedure




1. Align the machined side of the flywheel assembly, with the machined side of the cover.




2. Install the J 43482 in order to support the clutch cover to the flywheel assembly.





Notice: Refer to Fastener Notice.

3. Install the clutch cover to flywheel bolts.

Follow the tightening sequence. Tighten the bolts to 24 N.m (18 lb ft).

4. Remove the J 43482.

Important: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.

5. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
6. Install the transmission. Refer to Transmission Replacement for the - M86/M94 Getrag transaxle.
7. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding.
8. Connect the negative battery cable.