Wiper Motor Replacement

Wiper Motor Replacement

Tools Required
* J 39232 Wiper Linkage Separator
* J 39529 Wiper Linkage Installer

Removal Procedure

1. Remove the wiper arms.
2. Remove the air inlet grille panel.




3. Remove the wiper drive system module.




4. Using J 39232, disconnect the wiper transmission links from the wiper motor crank arm.




5. Remove the 2 wiper motor bolts.
6. Remove the spacer (1) from the wiper drive system module (2)
7. Remove the wiper motor (3) from the wiper drive system module (2).
8. Remove the wiper motor module support bracket (4) from the wiper motor (3).

Installation Procedure




1. Install the wiper motor module support bracket (4) to the wiper motor (3).
2. Position the wiper motor (3) to the wiper drive system module (2).
3. Position the spacer (1) to the wiper drive system module (2).

Notice: Refer to Fastener Notice.

4. Install the 2 wiper motor bolts.

Tighten the bolts to 4.5 N.m (40 lb in).




5. Install the wiper transmission links onto the wiper motor crank arm with the J 39529.




6. Install the wiper drive system module.
7. Install the air inlet grille panel.
8. Install the wiper arms.
9. Inspect the washers for proper operation.