Manifold Pressure/Vacuum Sensor: Service and Repair

MANIFOLD ABSOLUTE PRESSURE SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).

NOTE: Do not rotate or pry on the MAP sensor when removing. Damage to the MAP sensor or the intake manifold may result.




2. Using a slight rocking motion, while pulling straight up, remove the MAP sensor.

3. Inspect the MAP sensor seal for damage, replace the seal, if necessary.

INSTALLATION PROCEDURE




1. Install a NEW MAP sensor seal, if necessary.
2. Install the MAP sensor.




3. Connect the MAP sensor electrical connector (2).