Timing Component Alignment Marks: Locations

Timing Component Alignment Marks (LC9/LMG/LY2/LY5)





Important:
^ The sprocket teeth and timing chain must mesh.

^ The camshaft and the crankshaft sprocket alignment marks MUST be aligned properly.

Position the camshaft sprocket (205) so the timing mark is in the 6 o'clock position.
Install the camshaft sprocket (205), timing chain (208), and bolt (206).




Inspect the sprockets for proper alignment. The mark on the camshaft sprocket (1) should be located in the 6 o'clock position and the mark on the crankshaft sprocket (2) should be located in the 12 o'clock position.




Remove the EN 46330.




Tighten the camshaft sprocket bolt
1. Tighten the bolt a first pass to 90 N.m (66 lb ft).
2. Tighten the bolt a final pass an additional 40 degrees using J 45059.




Remove the J 42386-A (1) and bolts.