License Plate Lamp: Service and Repair

REAR LICENSE LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Remove the 2 screws that retain the license lamp lens to the liftgate.




2. Remove the license lamp lens from the liftgate.
3. Remove the bulb (1) from the socket.

INSTALLATION PROCEDURE




1. Install the bulb (1) to the socket.
2. Wipe the bulb to ensure the bulb is free of dirt or oil.




3. Position the license lamp lens to the liftgate.
4. Verify that the license lamp lens gasket is fully seated to the liftgate.

5. NOTE: Refer to Fastener Notice.

Install the 2 license lamp lens retaining screws.

Tighten the screws to 1.4 N.m (12 lb in).