Input Speed Sensor Replacement

Input Speed Sensor Replacement

Removal Procedure

1. Remove the battery tray . Refer to Battery Tray Replacement .




2. Disconnect the electrical connector (4) from the input speed sensor.




3. Remove the input speed sensor bolt.
4. Remove the input speed sensor.
5. Remove the input speed sensor O-ring. Discard the O-ring.



Installation Procedure





1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new input speed sensor O-ring.
2. Install the new input speed sensor O-ring onto the input speed sensor.
3. Install the input speed sensor to the transaxle.

Notice: Refer to Fastener Notice .

4. Install the input speed sensor bolt.

Tighten the bolt to 6 N.m (53 lb in).





5. Connect the electrical connector (4) to the input speed sensor.
6. Install the battery tray . Refer to Battery Tray Replacement .