Output Speed Sensor Replacement

Output Speed Sensor Replacement

Removal Procedure

1. Remove the battery tray. Refer to Battery Tray Replacement .




2. Disconnect the electrical connector (2) from the output shaft speed sensor.




3. Remove the output speed sensor bolt.
4. Remove the output shaft speed sensor and the O-ring.



Installation Procedure





1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new output speed sensor O-ring.
2. Install the new output speed sensor O-ring onto the output speed sensor (2).
3. Install the output speed sensor into the transmission case assembly.

Notice: Refer to Fastener Notice .

4. Install the output speed sensor bolt.

Tighten the bolt to 6 N.m (53 lb in).





5. Connect the electrical connector (2) to the output shaft speed sensor.
6. Install the battery tray. Refer to Battery Tray Replacement .