Turn Signal Lamp: Service and Repair

Parking and Turn Signal Lamp Replacement

Removal Procedure

Warning:
Refer to Battery Disconnect Warning Battery Disconnect Warning.


1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

Note:

* For left park/turn signal lamp access, go to step 3.

* For right park/turn signal lamp access, go to step 5.





2. For access to the left park/turn signal lamp, release the air cleaner cover retaining clips (1).





3. Detach and move the air cleaner upper cover (1) rearward.





4. For access to the right park/turn signal lamp, disconnect the coolant recovery hose (2) from the coolant recovery reservoir filler neck (1).





Note:
Remove the coolant recovery reservoir filler neck by pulling upwards. Allow the coolant recovery reservoir filler neck to drain before completely removing it from the vehicle.

Note:
Place a clean workshop cloth over the opening of the coolant recovery reservoir immediately after removing the coolant recovery reservoir filler neck to prevent contamination of the coolant.

5. Remove the coolant recovery reservoir filler neck (1).





Note:
Rotate the park/turn signal lamp socket (2) counter-clockwise to remove.

6. Remove the park/turn signal lamp socket (2) from the headlamp assembly (1).





Note:
Rotate the park/turn signal lamp bulb (2) counter-clockwise to remove.

7. Remove the park/turn signal lamp bulb (2) from the park/turn signal lamp socket (1).

Installation Procedure





Note:
Push and rotate the park/turn signal lamp bulb (2) clockwise to install.

1. Install the park/turn signal lamp bulb (2) to the park/turn signal lamp socket (1).





Note:
Rotate the park/turn signal lamp socket (2) clockwise to install.

2. Install the park/turn signal lamp socket (2) to the headlamp assembly (1).





Note:
Ignore step 3 if access to the right park/turn signal lamp bulb was required.

3. Reposition the air cleaner upper cover and secure the air cleaner cover retaining clips (1).





Note:
Ignore steps 4 and 5 if access to the left park/turn signal lamp bulb was required.

Note:
Align the tab and keyway (2) and push the coolant recovery reservoir filler neck (1) down into the coolant recovery reservoir (3).

4. Install the coolant recovery reservoir filler neck (1) into the coolant recovery reservoir (3).





5. Connect the coolant recovery reservoir hose (2) to the coolant recovery reservoir filler neck (1)

6. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

7. Check all vehicle lights for correct operation.