Turn Signal Switch: Service and Repair

Turn Signal Switch Replacement

Removal Procedure

Warning:
Refer to Battery Disconnect Warning Battery Disconnect Warning.


1. Disconnect the battery ground cable from the battery. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

2. Remove the upper and lower steering column trim covers. Refer to Steering Column Trim Cover Replacement Steering Column Trim Cover Replacement.





3. Disconnect the turn signal switch (2) electrical connector (1).





4. Press the retaining tabs (2) on the turn signal switch (1) and pull the turn signal switch assembly away from the steering column.

Installation Procedure





1. Install the new turn signal switch (1) and push the switch into position until the retaining tabs (2) seat with an audible click.





2. Connect the turn signal switch (2) electrical connectors (1).

3. Install the upper and lower steering column trim covers. Refer to Steering Column Trim Cover Replacement Steering Column Trim Cover Replacement.

4. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection (Primary) Battery Negative Cable Disconnection and Connection (Primary)Battery Negative Cable Disconnection and Connection (Auxiliary) Battery Negative Cable Disconnection and Connection (Auxiliary).

5. Check all vehicle lights for correct operation.