Starter Motor: Service and Repair

REMOVAL

Remove And Install Battery Cable:

1. Disconnect battery negative cable.
2. Raise vehicle.
3. For easier servicing, do not remove the wiring from starter at this time.

Starter:

4. Remove three bolts attaching starter to engine.
5. Remove starter solenoid assembly from transmission housing. Position the starter to gain access to the wiring connectors.

Wire Terminal Connection:

6. Remove the battery positive cable nut from starter and remove cable.
7. Disconnect push on solenoid connector.
8. Remove the starter from vehicle.

INSTALLATION
- For installation, reverse the above procedures. Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid.