Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 1997 >> Sebring Convertible L4-2.4L VIN X >> Repair and Diagnosis >> Wiper and Washer Systems >> Wiper Motor >> Service and Repair >> Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Replacement

Linkage Removal:





WIPER MOTOR REMOVAL
1. Remove wiper arms and blades.
2. Remove the cowl screen.
3. Remove wiper motor assembly
4. Disconnect drive linkage from motor output crank. Using an ball joint/tie rod separator, separate the ball cap from the ball.
5. Remove motor mounting nuts and remove motor.
6. Disconnect wire connector at motor.

WIPER MOTOR INSTALLATION
- For installation, reverse the above procedures. Tighten the mounting screws to 10 to 12 N.m (89 to 106 in. lbs.) torque. Ensure that the motor connector seal is properly positioned. Tighten the motor mounting nuts to 25 to 30 N.m (19 to 23 ft. lbs.) torque.

Wiper Motor And Linkage Module:






WIPER MOTOR ASSEMBLY REMOVAL
1. Remove wiper arms and blades.
2. Remove the cowl screen.
3. Remove the four wiper motor mounting screws then lift assembly to gain access to clip.
4. Disconnect harness clip from the forward mounting leg.
5. Disconnect wire connector at motor and remove assembly

WIPER MOTOR ASSEMBLY INSTALLATION
- For installation, reverse the above procedures. Tighten the mounting screws to 10 to 12 N.m (89 to 106 in. lbs.) torque. Ensure that the motor connector seal is properly positioned.
pro multis · About Operation CHARM