Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 1998 >> Sebring Convertible L4-2.4L VIN X >> Repair and Diagnosis >> Body and Frame >> Interior Moulding / Trim >> Dashboard / Instrument Panel >> Service and Repair >> Junction Block Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Junction Block Replacement

REMOVAL

Junction Block/BCM Location:




The Junction Block and Body Control Module (BCM) are attached to each other. After removal they can be separated. Junction Block and Body Control Module assemblies are located on the driver's side of the vehicle.
1. Open the front driver's door and remove end cap.
2. Remove center bezel.
3. Remove instrument cluster hood.
4. Remove silencer.
5. Remove wire harness connectors from Junction Block.
6. Remove Junction Block three mounting screws.
7. Remove Junction Block/BCM by pulling straight down from the mounting bayonet.
8. Disconnect BCM wire connectors and remove the assembly.
9. Remove Junction Block (BCM) from vehicle.

INSTALLATION
For installation reverse the above procedures. Ensure that the wire terminals and connectors are in good condition and connectors are properly installed.
pro multis · About Operation CHARM