Headlamp Washer Spray Nozzle: Service and Repair

HEADLAMP WASHER NOZZLE - EXPORT REPLACEMENT

REMOVAL
1. Hoist vehicle.
2. Partially remove the front fascia to gain access to the headlamp assembly. Refer to Body for REMOVAL procedures.
3. Remove the headlamp assembly. Refer to Electrical, Lamps/Lighting - Exterior, Headlamp Unit, REMOVAL.

Fig. 5 Headlamp Washer Nozzle:

4. Remove the headlamp washer nozzle retaining screws and remove the nozzle from the headlamp assembly.

INSTALLATION
1. Place the headlamp washer nozzle in position on the headlamp assembly
2. Install the headlamp washer nozzle retaining screws. Torque to 0.7 to 1.3 Nm.
3. Reinstall the headlamp assembly Electrical, Lamps/Lighting - Exterior, Headlamp Unit, INSTALLATION.
4. Reinstall the front fascia as necessary. Refer to Body for INSTALLATION procedures.
5. Lower vehicle from hoist.
6. Refill the washer fluid.
7. Prime the headlamp washer system. Refer to the Electrical, Wipers/Washer, Headlamp Washers, Standard Procedures - Headlamp Washer System Priming.