Compass: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove overhead console. Refer to Overhead Console Removal and installation.
3. Remove the screws holding the compass mini-trip computer (CMTC) module in the overhead console.
4. Disconnect the CMTC module electrical connector.
5. Remove CMTC module from console assembly.

NOTE: If the CMTC module is being replaced, the tire pressure monitoring system must be retrained.

Refer to the Tires/Wheels section for detailed instructions.

INSTALLATION
1. Position the CMTC module in the overhead console and connect the electrical connector.
2. Install the screws holding the CMTC module in the overhead console.
3. Install the overhead console.
4. Connect the battery negative cable.

NOTE:
- If the CMTC module is being replaced, the tire pressure monitoring system must be retrained. Refer to the Tires/Wheels section for detailed instructions.
- If a new CMTC module has been installed, the compass will have to be calibrated and the variance set. Refer to compass variation adjustment and compass calibration in standard procedures.