Tail Lamp: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Tail Lamp Unit - Remove/Install:

2. Open liftgate, remove two hex head bolts in inner D-pillar.
3. Rotate lamp outboard away from vehicle to remove tail lamp forward stud from grommet.
4. Disconnect electrical connector.
5. If replacing the tail lamp unit, transfer lamps to new unit.

INSTALLATION
1. If replacing the tail lamp unit, transfer lamps to new unit.
2. Connect electrical connector.
3. Place tail lamp unit over retaining clip and push to seat in clip until you hear a snap.
4. Install the hex head nut into the D-Pillar.
5. Connect the battery negative cable.
6. Verify vehicle and system operation.
7. Close liftgate.