Vanity Lamp: Service and Repair

REMOVAL
1. Open hood, disconnect and isolate the battery negative cable.
2. Open door.

Vanity Lamp Lens - Removal:

3. Using a trim stick (special tool #C-4755) or equivalent, gently pry out on vanity lamp lens and remove from the vanity.

Vanity Lamp - Removal:

4. Gently pry up on the edge of the lamp and pull out of the vanity unit to remove.

INSTALLATION
1. Place lamp over retaining clips in vanity unit retaining dips and firmly snap into place.
2. Place the vanity lamp lens over the retaining slots making sure that they are lined up and them firmly snap into place.
3. Connect the battery negative cable.
4. Close hood.
5. Verify vehicle and system operation.
6. Close door.