Power Distribution Module: Service and Repair

REMOVAL

NOTE: When a replacement IPM is installed in the vehicle, the IOD fuse must be rotated to the "customer" position.

1 Disconnect and isolate the battery negative cable.
2 Remove the hood cable retaining clip near the Integrated Power Module (IPM).

Integrated Power Module:

3 Using a flat bladed tool, depress the four locking tabs on the side of the IPM.
4 Lift the IPM from the bracket.
5 Disconnect the electrical harness connectors from the IPM.
6 Disconnect the battery connection to the IPM by removing the nut attaching the connection to the bolt.

INSTALLATION
1 Install battery connection and retaining nut. Tighten nut to 28 N.m (250 in. lbs.)
2 Connect the electrical harness connectors to the Integrated Power Module (IPM).
3 Position IPM into place, and lock into position.
4 Install the hood cable retaining clip.
5 Connect battery negative cable.