Installation

INSTALLATION





1. Inspect the O-ring for damage before installing the tube (1). Replace O-ring as necessary.
2. Lubricate O-ring with MOPAR(R) Dielectric Grease and install inlet tube into the cylinder block opening.
3. Install inlet tube bolts and tighten to 12 Nm (105 in. lbs.).
4. Connect lower radiator hose and heater return hose to inlet tube.
5. Install upper radiator closure panel and center brace Installation.
6. Fill cooling system Service and Repair.
7. Pressure test system to 103 kPa (15 psi) and check for leaks.