Removal

REMOVAL





NOTE: It is not necessary to remove the Steering Column Control Module (SCCM) from the steering column to replace the left multi-function switch.

1. Disconnect and isolate the battery negative cable.

WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag or steering column components.

2. Remove both the upper and lower shrouds from the steering column Removal and Removal.
3. Remove the one screw (3) that secures the right multi-function switch (2) on the right side of the SCCM (1).




4. Pull the switch (2) straight away from the SCCM (3) far enough to access the electrical connector (1) to disconnect it from the SCCM.
5. Remove the switch (2) from the SCCM (3).