No-Load Current Test

Fig. 2 No-load current test connections:

1. Connect test equipment as shown, and turn tester load control knob fully counterclockwise, then operate starter and note voltage.
2. Using mechanical tachometer, determine exact motor RPM. Connect tachometer by removing seal from end of drive end housing and clean grease from end of armature shaft.
3. Disconnect battery cable from starter.
4. Turn load control knob clockwise until voltage reading is exactly that obtained in step 1.
5. If ammeter does not read 67 amps with a starter motor RPM of 7380---9356, repair or replace starter as necessary.