A/T Overdrive Switch - Removal Procedure
90AMCJEEP06 Models1989-1990 B2
Subject
Automatic Transmission Overdrive Switch Removal Procedure
Index
TRANSMISSION
Date
August 13, 1990
No.
21-51-90
P-2319 (C21-14-0)
BODY CODE LEGEND
B2 - SUMMIT
DISCUSSION
To prevent damaging the overdrive (OD) transmission selector knob when removing the overdrive switch, the following procedure should be followed:
PROCEDURE
1. Remove the transmission selector knob as outlined in the appropriate service manual.
2. Place the OD switch in the "OFF" position, (the switch button protrudes).
Figure 1:
3. Using a small flat blade screwdriver gently pry the button loose as shown in Figure 1.
Figure 2:
4. Holding the OD switch plunger in the depressed (ON) position carefully remove the OD switch from the selector knob, Figure 2.
5. To install the switch reverse the procedure.
POLICY: Information only.