Horn Chirp Cancellation

HORN CHIRP CANCELLATION

During the programming operation the horn chirp can be disabled using the following procedures:

1. Locate the Data Link Connector under the instrument panel right of the steering column.

2. Turn ignition switch to the ON position.

Data Link Connector:

3. Ground Pin 1 of the Data Link connector. This is the programming line for the Remote Keyless Entry Module. The door locks will lock and unlock, to indicate the receiver is ready to receive transmitter code. The trunk solenoid will not cycle at this time.

4. Press any button on the transmitter to set code. The locks will cycle to confirm programming. If there is a second transmitter, it must be set at this time. Press any button on the second transmitter and wait for the locks to cycle.

5. Using one of the transmitters, press the transmitter LOCK then UNLOCK buttons. Repeat two more times.

6. Door locks and trunk release will cycle three times as feedback of Horn Chirp Lockout.

7. Disconnect the program line from ground. This returns the system to its normal operation mode.

8. To reinstate the Horn Chirp feature, simply reprogram the module. Refer to Remote Keyless Entry Transmitter Programming.