Backup Lamp: Service and Repair

LH/CP

REMOVAL
1. Release trunk latch and open trunk.
2. Remove rear closure lining as necessary to gain access to tail lamp fasteners.

Tail, Stop, Back-up And Turn Signal Lamp:

3. Remove wing nuts holding tail lamp to rear closure panel.
4. Disengage tail lamp wire connector from body wire harness.
5. Disengage rubber grommet from rear closure panel.
6. Separate tail lamp from rear closure panel.
7. Pull tail lamp wire harness through hole in rear closure panel.
8. Separate tail lamp from vehicle.

INSTALLATION
1. Place tail lamp in position on vehicle.
2. Push tail lamp wire harness through hole in rear closure panel.
3. Engage rubber grommet into rear closure panel.
4. Place tail lamp in position on rear closure panel.
5. Engage tail lamp wire connector to body wire harness.
6. Install wing nuts to hold tail lamp to rear closure panel.
7. Install rear closure panel lining.
8. Verify tail lamp operation.