LH/CP

REMOVAL
1. Release hood latch and open hood.
2. Remove radiator closure panel sight shield as necessary to gain access to bubble level.

Headlamp Bubble Level:

3. Using a small flat blade screw driver, pry upward on the retaining tabs at the front of the level.
4. Push level rearward until retaining tabs disengage from the channels on the sides of the level.
5. Separate level from vehicle.

INSTALLATION
1. Place level in position on vehicle.
2. Push level forward until retaining tabs slide into the channels at the sides of the level.
3. Calibrate bubble level. Refer to Headlamp Bubble Level Calibration in Headlamp Alignment.
4. Install radiator closure panel sight shield.