Windshield Washer Pump: Service and Repair

REMOVAL
1. Remove liquid from reservoir.
2. Disconnect battery terminals. Remove battery and tray.
3. Disconnect electrical lead and rubber hose from bottom of pump.
4. Remove two reservoir retaining nuts and screw, then remove reservoir.

Washer Pump:

5. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
6. Remover rubber grommet from reservoir and throw away.

INSTALLATION
- For installation, reverse the above procedures. Tighten the reservoir nuts and screw to 9 to 14 N.m (80 to 124 in. lbs.) torque. Fill reservoir.