Condenser HVAC: Service and Repair

1. Discharge refrigerant from system.
2. Disconnect compressor discharge line and liquid line from condenser and cap both lines.
3. Remove two screws attaching hood latch to radiator support and position latch aside.
4. Remove nine screws attaching top edge of radiator grille to radiator support.
5. Remove screw attaching center area of grille to grille center support.
6. Remove grille center support to radiator support attaching screw.

Fig. 1 Receiver & condenser assembly:

7. Working under vehicle, reposition splash shields and remove two condenser lower retaining nuts, Fig. 1.


8. Remove two bolts attaching top of condenser to radiator upper support.
9. Remove four bolts attaching each end of radiator upper support to radiator side supports.
10. Pull top edge of grille forward, remove radiator upper support, and lift condenser from vehicle.
11. Reverse procedure to install. Use new O-rings lubricated with refrigerant oil.
12. Leak test, evacuate and charge system. Check system for proper operation.