Ignition Lock Replace

1. Remove steering column trim shroud.
2. Disconnect key warning switch electrical connector.
3. Turn ignition lock to ``On'' or ``Run'' position.
4. Using a 1/8 inch pin or punch located in the 4 o'clock hole and 1-1/4 inch from outer edge of lock cylinder housing, depress retaining pin while pulling the lock cylinder from housing.
5. Turn lock cylinder to ``On'' or ``Run'' position and insert cylinder into housing. Ensure lock cylinder is fully seated and aligned into interlocking washer before turning key to ``Off'' position. This will permit retaining pin to extend into lock cylinder housing hole.
6. Rotate key to check for proper mechanical operation.
7. Connect key warning switch electrical connector.