Condenser HVAC: Service and Repair

Fig. 2 Spring lock coupling disconnect & connect:

1. Discharge refrigerant from system.
2. Drain coolant from radiator.
3. Remove battery and heat shield.
4. Disconnect refrigerant line fittings on the right side of radiator, Fig. 2.
5. Remove two fan shroud attaching screws, then position fan shroud rearward.
6. Disconnect upper hose from radiator.
7. Remove the two radiator retaining clamps and tilt radiator rearward.

Fig. 3 Condenser assembly removal:

8. Remove two screws attaching the top of the condenser to radiator support, Fig. 3.
9. Lift condenser from vehicle and cap refrigerant lines to prevent entry of dirt and excessive moisture.
10. Reverse procedure to install.
11. Leak test, evacuate and charge system.