Installation

For additional information see Notes, Warnings, and Hints.

NOTICE: Use caution to prevent brake fluid from contacting brake linings or they must be replaced. Wipe the end of the hydraulic line to remove any foreign matter before making connections.

1. Position wheel cylinder on backing plate and finger-tighten brake tube to cylinder.
2. Secure cylinder to backing plate by installing retaining bolts. Tighten bolts to 10-14 Nm (8-10 ft lb).
3. Install tube nut fitting (using a tube nut wrench). Tighten fitting nut to 16-20 Nm (12-14 ft lb).
4. Install and adjust brakes.