Rear Door Glass

The rear door glass has in and cut and fore-and-aft adjustments. The in and out adjustment may be accomplished by loosening the two screws in the lower glass bracket assembly and moving the glass in or out as required. The fore-and-aft adjustment is accomplished by loosening the tube run upper screw and washer assembly, loosening the lower nut and washer assembly attaching the rear door run and bracket assembly to the inner door panel, and adjusting the glass fore or aft as required.

When setting the glass to the window opening, lower the glass approximately 50mm (2 inches) from full-up position with the four retention points loosely installed. Set the glass forward into the B-pillar and tighten lower run nut and washer No.1, then Nos. 2 and 3.