Speed Control/Horn Brush Contact Plate

1. Pull upward on upper middle edge of the horn cover/pad assembly and separate it from the steering wheel.
2. Disconnect horn switch electrical connectors from horn cover/pad assembly, then set the assembly aside.
3. Disconnect electrical connector from the speed control/horn brush contact plate terminal.
4. Remove and discard steering wheel attaching nut.
5. Using a puller, remove steering wheel from shaft. To prevent damage never hit steering wheel attaching bolt or use a knock-off type steering wheel puller.
6. Working from back side of steering wheel, remove three retaining screws, then the speed control/horn brush contact plate.
7. Reverse procedure to install.