System Reactivation Procedures

To Reactivate System:

WARNING: THE AIR BAG SIMULATOR(S) MUST BE REMOVED AND THE AIR BAG(S) RECONNECTED WHEN THE SYSTEM IS REACTIVATED.

1. Disconnect battery positive cable.
2. Remove Rotunda Air Bag Simulator 105-00010 or equivalent from air bag terminals on clockspring assembly, if connected.
3. Reconnect driver air bag module connector.
4. Position driver air bag module on steering wheel and secure with four nut and washer assemblies (10 mm). Tighten nut and washer assemblies to 4-5.6 N.m (36-49 lb-in).
5. If vehicle is equipped with a passenger side air bag, remove Rotunda Air Bag Simulator 105-00010 from the wiring harness, reconnect passenger side air bag and install.
6. Connect battery positive cable.
7. Verify air bag indicator.