Wiper Arm: Service and Repair

REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.
2. Remove wiper pivot arms from the windshield wiper mounting arm and pivot shaft.
3. Remove the cowl vent seal and raise outer air inlet cowl slightly.
4. Remove the motor drive arm-to-linkage mounting arm and pivot shaft assembly retaining clip.
5. Remove washer jets from cowl vent grille.
6. Remove cowl grille.
7. Remove wiper motor attaching bolts, then remove motor.
8. Remove pivot body-to-cowl panel attaching screws, then the arm and pivot shaft assembly.
9. Reverse procedure to install.