QC2 - Request to Remove P1000

- A complete On-Board Diagnostics II (OBD II) Drive Cycle has not yet been performed to remove the DTC P1000 from the Powertrain Control Module (PCM).

- Has the customer requested the P1000 be removed from the PCM memory?

YES -- PERFORM the OBD II Drive Cycle. Monitors, Trips, Drive Cycles and Readiness Codes

If DTC P1000 is still present, GO to QC3. QC3 - Check VSS PID

NO -- No faults in the Electronic Engine Control-V (EEC-V) system have been detected. INFORM the customer that if the law in this state requires additional driving in order to remove the DTC P1000 from the PCM memory, it must be performed before an inspection/maintenance test. RETURN to Symptom Flowcharts if any other symptoms are present. Testing and Inspection