Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 1994 >> Ranger 4WD V6-182 3.0L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Wheel Speed Sensor
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wheel Speed Sensor

REMOVAL
1. At the rear axle housing pull the wiring harness connector from the speed sensor.
2. Remove the speed sensor hold down bolt and remove the speed sensor from the rear axle housing.

INSTALLATION
1. Clean the rear axle housing mounting surface. Use care to prevent dirt from entering the rear axle housing.
2. Inspect and clean the magnetized sensor pole piece to make sure that it is free from loose metal particles which could cause erratic� system operation. Inspect the speed sensor O-ring for damage and replace if necessary.
3. Lightly lubricate the speed sensor O-ring with motor oil, align the bolt hole, and install.

NOTE: Do not apply force to the plastic sensor connector. The sensor flange should slide to the mounting surface. This will make sure the air gap setting is between 0.127-1.143 mm (0.005-0.045 inches).

4. Install the speed sensor hold-down bolt and tighten to 34-40 Nm (25-29 ft. lbs.).
5. Push the connector on the speed sensor.

pro multis · About Operation CHARM