Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 1994 >> Taurus V6-182 3.0L FF >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Crankshaft Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Crankshaft Position Sensor: Service and Repair

REMOVAL
1. Disconnect battery ground cable.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

2. Disconnect Crankshaft Position (CKP) sensor from the engine control sensor wiring.
3. Remove retaining bolts and remove CKP sensor.

INSTALLATION






1. Make sure CKP sensor mounting surface is clean.
2. Position crankshaft position sensor and install retaining bolts. Tighten to 5-7 Nm (44-61 lb in).

CAUTION: Do not overtighten crankshaft position sensor retaining screw.

3. Properly route engine control sensor wiring and connect crankshaft position sensor wiring connector to crankshaft position sensor.
4. Connect battery ground cable.

pro multis · About Operation CHARM