Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Alignment: Service Precautions

NOTE: The air bag restraint system is an optional item on this model. Not all versions are equipped with it.

DISARMING
1. Disconnect battery ground cable, then the positive cable. Allow at least one minute for back-up power supply to deplete.
2. Remove four nut and washer assemblies retaining air bag module to steering wheel.
3. Disconnect air bag module connector.
4. Connect Rotunda Air Bag Simulator 105-00010, or equivalent, to vehicle air bag wiring harness at top steering column.
5. Connect battery positive cable, then the ground cable.

ARMING
1. Disconnect battery ground cable, then the positive cable. Allow one minute for back-up power supply to deplete.
2. Remove air bag simulator from harness on top of steering column.
3. Connect driver's air bag connector.
4. Install driver's air bag module. Tighten retaining screws to specifications.
5. Connect battery positive cable, then the ground cable.
6. Place ignition switch in RUN position and note air bag warning lamp operation. Indicator lamp should illuminate for approximately six seconds, then turn OFF.