TG95 - Check MLP Sensor Alignment

- Key Off.

- Apply parking brake.

- Place transmission in NEUTRAL.

- Verify the MLP tool (Rotunda T92P-7010-AH) or equivalent fits in the appropriate slot.

- Does the tool fit properly?

YES -- REMOVE tool. GO to TG101. TG101 - Check MLP Sensor Resistance

NO -- PLACE the transmission in NEUTRAL, loosen the two MLP sensor mounting bolts. MOVE the sensor about to allow insertion of the MLP sensor tool in the appropriate slots. TIGHTEN the two mounting bolts to specification. REMOVE the tool. VERIFY shift linkage adjustment. Complete PCM reset to clear DTCs. Clearing Diagnostic Trouble Codes

Rerun drive cycle test step TG90 to verify repair. TG90 - Perform Drive Cycle Test