Back Window Regulator: Service and Repair

Tailgate Window Regulator, Bronco


Removal

1. Lower tailgate and remove interior access cover panel (ten screws). If tailgate will not lower because glass will not go full down, manually depress safety lockout rod (located in bottom center of tailgate).

2. Raise glass using jumper to motor (or manually close left tailgate latch). If the glass will not go up, glass must be removed as outlined.

3. Remove regulator attaching screw and washer assemblies.

4. Remove regulator.


Installation

1. Position regulator in tailgate and secure with four screw and washer assemblies. Tighten to 9-14 N-m (6-11 ft-lb).

2. Install glass as outlined.

3. Check operation of regulator.

4. Install interior access cover panel.