Ignition Control Module: Service and Repair

REMOVAL
1. Disconnect ignition control module electrical connector by pushing down on the connector finger ends while grasping the connector body and pulling away from the ignition control module (ICM).

Ignition Control Module:

2. Remove two ignition control module retaining screws and remove ignition control module.

INSTALLATION
1. Position ignition control module to front fender and install retaining screws. Tighten to 3-4 Nm (24-35 in lb).
2. Connect ignition control module electrical connector by pushing until connector fingers are locked over locking wedge feature on ignition control module. Locking the connector is important to ensure sealing of the connector and ignition control module interface.