Park/Neutral Position Switch (Manual Transaxle Only)

Park/Neutral Position Switch:

REMOVAL
1. Raise and support the vehicle.
2. Drain the transmission fluid.
3. Disconnect the Park/Neutral Position (PNP) switch electrical connector.
4. Remove the PNP switch and discard the gasket.

INSTALLATION
1. Install the PNP switch using a new gasket.
2. Tighten the switch to 20-29 Nm (14-22 lb ft).
4. Connect the electrical connector.
5. Lower the vehicle.
6. Fill the transaxle with fluid.
7. Ensure proper operation of the PNP switch.